Fixed your Netgear Extender Disconnecting issues

The issue of transforming dead areas to fun areas was successfully resolved with the Netgear wifi range extenders and the increased WiFi signals by up to 30%. Netgear Range Extenders enhance internet signals from your primary router and provide continuous Internet access to all wired and wireless devices even in regions with low connection.

While the Netgear WiFi extension provides unbelievable capabilities, it may sometimes spin customers’ leaders with different problems. And, indeed, one of the most frequent but important is the Netgear WiFi Extender that continues to disconnect

If you’re angry over the same problem, don’t panic! Your concerns are understood. This is why we have developed a guide to make it easy for you to solve the problem. Let’s read this! Let’s read it!

Connect to correct Network Name 

The extender will provide you an extender of the WiFi network name after a successful Netgear EX6100 extender setup. This network may have SSIDs different from the last. Instead of the new one, your devices will probably connect with the old WiFi network. This may lead to Netgear’s WiFi extension that continues to disconnect. Therefore, you just need to connect to the network name of your exporter to solve the problem.The Netgear WiFi extender may also be resolved by a simple power cycle procedure that remains disconnected. To do so, just disconnect your Netgear extension and connect it again after a few minutes.

Place Your Netgear Extender Away From Interference

Check your Netgear extension if you are still experiencing the problem again and again. Don’t put the device next to those gadgets that interfere with the WiFi signals of your Netgear extender. You won’t be able to receive continual internet signals throughout your home if you put your device next to thick or concrete walls. Therefore, reload your device and repair extension problems.

Install the most recent firmware versions On your Netgear extender

Wireless Netgear extender ranges are included into the “Firmware” programme. But, with time, the software may be out of date and the source of the problem. So verify whether the firmware on your extension is up to date or not to get rid of the problem. Just check mywifiext.net and see the newest version of firmware. If you are unable to do so, upgrade your firmware by following the on-screen instructions.

Restore your Netgear extender

If none of the above solutions has addressed your problem, proceed to the Netgear reset extension procedure. Resetting the Netgear extension removes any custom configurations established during the Netgear extender configuration. It is thus advisable to record the changes in the configuration before the Netgear reset extension procedure.

To reset the extender Netgear:

  • Take a thin item.
  • Insert it in the reset hole of the Netgear extension.
  • Keep the reset hole hold and release.

Restore your extender through the Netgear Genie installation process.

These were some of the best methods to solve the problem of ‘Netgear WiFi extender’ If the problem still strikes you visit the official website; mywifiext.

Leave a Reply

Your email address will not be published. Required fields are marked *